[FrankCastle]

Hey guys..

What's the easiest way to make the Tony Stark head fit on the Movie masters harvey dent body? The neck peg is too small for the head socket. Looking for an easy solution as I am not really into customizing yet. Thanks for any help.

[FrankCastle]

Seriously no reply??

[Kiddcade]

Get some Petroleum Jelly and a hot craft-glue gun.

You're going to want to treat the neck ball liberally with the petroleum jelly, then set it aside for a minute and get your craft-glue gun. Once it's heated up, fill the socket about 3/4 of the way with craft glue and while it's still hot, stick the neck joint into it. Let it dry this way. the Petroleum Jelly acts as a mold release and the glue takes on the shape of the balljoint, makes a nice little vacuum-seal around it and it's soft enough to have a bit of "give"

Afterwards. clean up. if any glue is sticking out the bottom of the socket just cut it off with a small blade. you'll be good to go.