A-Team 3 3/4" Figure Disassembly
 

The entire figure is made of soft plastic like the Indiana Jones torsos were. They can be fully taken apart with a hair dryer (but the shoulders are a pain to pull apart) The waist is made up of two parts, the ball joints piece and the waist itself. Their Neck ball joints are about the same size as the GI Joe ones, but GI Joe heads look a little small on the bodies (except for some of the larger heads) Also the A-Team necks are a bit shorter than many GI Joe ones, so some GI Joe heads sit lower on the neck.

Nice! Thanks for posting that, man!

Very useful information. Thanks. I've been on the lookout for these but have yet to find them.

Very awsome that they are ball joint heads. I think I will pick these up when they hit shelves. THANKS SHOGI

Thanks for the info! I'm sure that will help kitbashers looking to turn a couple Facemen into Tomax/Xamot.

That last pic of the swapped heads is mindly disturbing, though - like something from Alice in Wonderland.

How do the bodies compare in size to GI Joe's?

They're close to the same size (Slightly shorter though)

Thanks a million for doing this, saves everyone here trial&error. Very considerate man.

Thank you!