Need Repair Advice: Toybiz 18" Spiderman
 

I had the old guy handing from the ceiling and when trying to pose it the bottom half came out.

The connection tab is semi soft plastic, however there is no room to try so slide it back in. It also has no screws whatsoever, so I have no idea of how to even begin cracking this thing open. It is also an old figure, so I could not find any repair attempts on Google.

Does anyone has any experience opening / repairing this figure?

Thanks in advance!

i suggest you try boiling some water, then dip the abdominal section, the hole area in the water. This should soften the plastic making it flexible, see if you can connect the two bits together. Maybe but i dont have one this might work...

Hi! I know this post is a little old, but today my son's toy broke exactly at the same point.

Did you finally find any working solution?

Kind regards and thank you in advance!

as long as not plastic is cracked/broken off, you should be able to use this boiling water solution. Or, if you prefer, you can also just hold a hair dryer to the bottom half. The key is just to only heat up one of the parts