[jimsloth]

So after seeing someone else switch out scarlet spider parts for deadpool I figured it was time to give it a try. I'm going to do this tutorial style for those who care.
First I picked the blaster pack Deadpool, because his red matched Scarlet Spider's much closer than the single carded version. I boil and popped the legs off at the thigh swivel, then cut out the pin and pulled off the hip balls (snicker).



Then I used snips to cut out the hip discs and tried to drill them down out of the way. Next I measured a Marvel Universe T bar I had previously scraped from a multiple man. I used my digital calipers to find the thickness of the post so I knew which drill bit to pick.


I also measured the distance up from the bottom of the crotch before drilling my new hole (snicker snicker).


Now I took my saw frame and carefully cut up the seem.


I turned the torso 90* so I could cut as far up the seem as possible


Then I took a flat screw driver I sanded to be extra wedge/flat/sharp.


I carefully snapped the lower torso apart.


Now I could carve a bit on the inside to make room for the top of the T bar.


Glued the torso back together. My screw driver left a tiny seem gap, so I used green stuff to fill it in. Luckily Deadpool has black there, so I won't have to worry as much about paint matching.


I could be done now, just paint the pouches on the scarlet spider's ankles...


But instead I boil and popped the knees off and added Deadpool's original lower legs. This got him closer in height to his counterpart.