[Jason Abbadon]

Quote:

Originally Posted by behindthemask

well when you get the headsculpt, you'll notice it's rock hard, bright white, and I had to wash mine a bid to get some the mold casting off, and the ball mount in the head was a bitch to get on, I took the head layed it down on a towel and forced the 2020 body onto it, once it got on then it's golden, a sweet amount of range of motion up and down, side to side etc, and the sculpt is badass I just need to mix up some fleshtone and tackle this badboy.

With any resin product, wash the hell out of it with Comet cleanser (mildly abrasive it removes mold release agents and gives primer a surface to latch onto.
PRIMER YOUR PART before painting!
Really, it's the only way to get paint to stick smoothly to most cast parts without globbing it on.


Also, warm water and a hand drill will get you easily remove some of that tight peg-hole giving you troubles (insert joke here, I know).

Or you could sand down the neck peg on the classic armor- whichever.
His head just looks too big on that body- that's a 4" scaled head on a 3.75" body- he's Tony Stark, not the Pep Boys guy!