[thechris]

Quote:

Originally Posted by Tiberius

I have to open 90% of my figures unless it is a comic con exclusive of some sort. However I really, really like the packaging to MOTUC so if I can I am going to try my hardest to save as much as the packaging I can.

What I do is take an exacto knife and follow the edge of the corner on the bottom on each side of the blister and then a cut where the blister meets the card. This essentially creates a resealable trap door where I can pull the figure out of the packaging from it's bubble, remove everything and then reinsert the bubble. This keeps both the card and front name insert intact. and would leave no visible signs of removal if I put the figure back and displayed it from the front.