[Th0r4z1n3]

Looking for some advice on adding peg holes to the feet of some 3 3/4" figures. My initial thought was to just take a drill with a small bit to the feet, but figured I'd ask around before I went around effing up my figures. LOL

For the record, I want to add peg holes to the 3 3/4" Mortal Kombat figures from Jazewares so that they can be placed on some of the figure stands from SmallJoes.com. They seem to use a rather rubbery plastic so I'm not sure if melting would be an issue and also not sure what size bit to use to get holes that will be snug but not too tight.

I have some other figures from various lines that I'd like to do this too also, but these are the ones I wanna start with.