[Dolemite]

Slight issue with Iron Man 2020's effect pieces. The hand repulsor pieces are fine, but the boot jet/exhaust pieces are made of a slightly soft (not ridiculously soft, but semi-soft) plastic. I set up IM2020 on my shelf with the boot jet effect pieces so he was hovering over the other figures and the next morning he had sagged backwards and would have fallen over if Crossbones wasn't there to support him.

The pegs on the boot jet pieces were 100% intact, and the holes on IM2020's feet are fine, but when you peg the boot jet pieces in it just doesn't feel 100% tight enough - like the pegs should have been maybe 2-3% bigger - and combined with the semi-soft plastic they kinda bend and/or slip out too easily. Plus the tops of the exhaust cloud pieces that the jet pieces insert into are also semi-soft, allowing a tiny bit of forward/back bend.

This is only a minor bummer, as I'm just beyond stoked to have an 1984 Iron Man 2020 figure and I didn't really care about the effect pieces, but it DID look cool with them. Oh, well. At least there are zero QC issue with the figure itself...strong plastic, tight joints, etc.

Anyone else having these problem with IM2020's boot jet effects?