[pmasterkim]

Hi all,

Wanted to show off my SP//DR figure.

This is a scratch build. I modeled in fusion 360 (with some edits to the main body using nomad sculpt) and then printed these off using the anycubic photon mono.

Paint was done by brush since I don't have an air brush

All the joints are double ball joints using hobby base clear joints, with exceptions to the wrist and ankles; these are swivels using cut offs from gunpla runners (got to use what you can.) Stand is a gunpla one.

Stands at about 8 inches but can be shorter/taller depending on how you position the floating limbs.