[RodimusVTS]

Ok no Dremel to deepen the hole? Grab your drill, and make the hole deeper. Then to make the hole tighter there are a couple of methods. There's Jim's method, or if you are planning to do more customizing you might want to get some green stuff/ kneadatite. It is great for filling neck balls, and as a sculpting material.

As for the super glue I use. It's Bob Smith industries Insta-cure+ Cyanoacrylate. I use the Gap Filling formula because it cures in 5-15. However if you're using it to tighten joints you still need to keep moving the joint for about 2-3 minutes.