[therealjustin]

I used a string of LED lights. If you do a search on eBay for "fairy LED lights" you can see what they look like. Basically a string of LED's with a battery box that you can position inside each light bar. Each half of my setup uses one string.


The design is very well made but it isn't perfect. Once you make two or three bays you start to understand where you might need to adjust certain folds, etc. in order for everything to fit properly.




Below are the templates I used. I chose to get rid of the bluish color on the backdrop because it looked ugly when I printed these on gray cardstock. Make sure to open these in a new tab so you can save the full size image and print at exactly 300 DPI on an 8.5 x 11 sheet for best results! These have been re-sized to fit 4" figures.