[CMIII]

ok wait... Yellow card Mattel. Lying... not 6 months ago you (Mattel) said

Quote:

We needed the tier 2 level (higher quota) of the 12 monthly partially tool’d figure to off-set the higher cost of the fully tool’d Doomsday.

that the Tooling would cost to much to produce Doomsday Unleashed. Now you say

Quote:

It is not the tooling that determines this, it is the production cost in terms of plastic and paint that physically make up a figure and this cost for a 6″ figure is pretty standard whether it is a redeco or a new figure. It would waiver more if said figure had larger parts like giant armor, wings or a tail because this would mean the figure needs more plastic and paint overall. The production run is also a factor and the fewer figures we make, the more expensive they are to produce. In 2014, Signature Series figures are $25.00 (not $20), the SP figures are priced higher at $30.00 due to the inclusion of a C&C piece, larger packaging and smaller production runs.

there is no extra cost on tooling. Be honest which is it? because I cannot be both. And do not play symantics with the Size of the figure