[vindowviper]

Quote:

Originally Posted by Grippen

Hi guys I fixed mine in a different way. Luckily the eBay seller I got mine from sent me a second set so I was not afraid of screwing her up completely.

I removed the clear rings from inside her shoulder. Joint is very tight so you need some patience. Also made a cut all the way down on the pin that goes inside the clear ring. This will ease the removal process. The pin is part of the arm cast.

Next I used a ring from a lower arm of a Gi joe figure. In my case used a 25th lady j because ofthe color. Female rings are smaller. although small still I had to trim it in order to fit the shoulder and pin. Once inside put a little glue on the pin side you cut and squeeze it. That's it.

Which I had photos of the process but I never took them. If someone is willing to send me their figures I think I can fix them.

I think I may try that. I think I have some ankle swivel hinges lying around that would require less trimming than anything else I've got. Thanks for sharing. I wasn't sure how cutting the pin would hold up, so it's good to hear it worked well for you.