[Penguino]

I've seen this before with Mattel figures. I was supposed to be welded together but wasn't.

It shouldn't split more but there isn't much that we can use that'll hold it together. Also popping the head on would probably break any glue seal you had. Also if this one is anything like mine then the 2 halves are so far apart that they'd pull away from the glue. They were designed to be tight enough for the ball joint on the head, so honestly glue will make a mess.

If the head's loose then that's about all you can fix. It sucks but it's the nature of Mattels figures. Unless you have a sonic welder and some factory paint you're most likely out of luck.


Someone may know something that'll work but for me it's been something I've had to live with.