[Augustus_Cole]

Quote:

Originally Posted by Trivial Psychic

Your best bet is to get a dremel and to work it around the edge of the peg hole just slightly. Don't rush it, as you could take too much off of it and it ends up not fitting.

@Sybmi....ya..dremel will be your new best friend (has lots of other uses too..plus they are relatively inexpensive)
..and the Don't rush it part is key...i ALWAYYYYYS do a little at a time and try it out...you can always take more off..but if you take too much off..there's no going back.
(well there is but now you're talking putty)
Compare the inside of the blade head to the inside of a head that fits the peg you're using...now you see where you need to be...

..and wear protective eyewear..little bits fly err'where..