Integration

Joe Moore · 10-10-2016, 07:03 PM

Quote:

Originally Posted by beckmen

My Narcissus lasted about half an hour out of the box. When I tried to remove it from the base, the peg broke off in the hole. I almost destroyed the whole thing trying to force the broken peg out.

Also, it's basically a big hunk of hollow plastic with a decent paint job. A lot more work goes into the cheaper 7" figures than this, I was kind of let down. For 25 bucks, it should have at least had some LEDs. On the fence as to whether or not I will buy future Cinemachines.

Whenever I run into a tight peg, just a little bit of heat will loosen that plastic up. I've done so many galleries, that I just keep a hair dryer handy for tight joints, pegs or tough assembly on some statues. For this, I hit it with the hair dryer for about 10 seconds and it came out. the first time the peg was a bit scratched due to me trying to force it out the first time.

10-10-2016, 07:03 PM	#5
Joe Moore Administrator Join Date: Oct 2008 Posts: 34,492	Quote: Originally Posted by beckmen My Narcissus lasted about half an hour out of the box. When I tried to remove it from the base, the peg broke off in the hole. I almost destroyed the whole thing trying to force the broken peg out. Also, it's basically a big hunk of hollow plastic with a decent paint job. A lot more work goes into the cheaper 7" figures than this, I was kind of let down. For 25 bucks, it should have at least had some LEDs. On the fence as to whether or not I will buy future Cinemachines. Whenever I run into a tight peg, just a little bit of heat will loosen that plastic up. I've done so many galleries, that I just keep a hair dryer handy for tight joints, pegs or tough assembly on some statues. For this, I hit it with the hair dryer for about 10 seconds and it came out. the first time the peg was a bit scratched due to me trying to force it out the first time. __________________