[LordMudd]

A long time ago I made some custom action figure stands for my DCIH figures, so I thought I would post here how I did it. You will need PowerAde or Gatorade, or similar bottle caps, a push pin, toothpicks, glue( hot glue, superglue, etc.).

Make a hole in the top of the cap off center. Push the toothpick thru the hole from outside to inside. If using dual point picks, clip off the end outside the cap. Put the figures foot on the pick and finish pushing it down. When you take the figure off you should have about an eighth of an inch sticking out. Cut off the bottom of the pick leaving a little extra and apply glue to hold it in place. This base will NOT let your figures fall over.

Here is a pic just to prove that figure was not glued on.



CCC.