Integration

Snowflakian · 07-02-2018, 05:05 PM

Extra odd, the captain america shield on the front is color swapped. Red and white are switched. Usually cap's shield has a red outer ring.

Quote:

Originally Posted by LordMudd

It is not 1:1, look at how deep the box is, unless it is in 2 pieces that snap together.

Which is unlikely that it's two halves, as that'd create a seem that'd keep it from looking screen accurate/would look kind of bad, Unless they did it as panels and a light up device that fits inside.

What are the measurements for an accurate 1:1 anyway? It's small enough to fit in Red Skull's hand, but depending on hand size, that can cause a couple square inch variance easily.

Quote:

Originally Posted by Black Arbor

Well the box is wider than it is deep, but since there's nothing in the pic to compare the size who knows how big the box will be?

It probably isn't a replica cube but I can dare to dream!

Depends on how deep the box is. However deep it is, is likely the cube size minus an inch or inch and a half for the packaging buffer area. Unless they went for the paneling method with a light up/electronics device the panels connect around. If it is a 6'' figure, we can likely assume the box is close to 8+ inches high. Or in that ballpark of a legends style packaging height. Which would make the box close to 3-4 Legends figure boxes in width. All rough estimates.

If they went panels method, bottom panel is likely connected already to the electronics device too for easier battery compartment access without having to take the cube apart and have an outside accessible switch to turn it on or off. That seems the most obvious no matter how they constructed it.

07-02-2018, 05:05 PM	#96
Snowflakian Illyria's New Qwa'ha Xahn Join Date: Feb 2009 Location: In the clouds. Posts: 4,120	Extra odd, the captain america shield on the front is color swapped. Red and white are switched. Usually cap's shield has a red outer ring. Quote: Originally Posted by LordMudd It is not 1:1, look at how deep the box is, unless it is in 2 pieces that snap together. Which is unlikely that it's two halves, as that'd create a seem that'd keep it from looking screen accurate/would look kind of bad, Unless they did it as panels and a light up device that fits inside. What are the measurements for an accurate 1:1 anyway? It's small enough to fit in Red Skull's hand, but depending on hand size, that can cause a couple square inch variance easily. Quote: Originally Posted by Black Arbor Well the box is wider than it is deep, but since there's nothing in the pic to compare the size who knows how big the box will be? It probably isn't a replica cube but I can dare to dream! Depends on how deep the box is. However deep it is, is likely the cube size minus an inch or inch and a half for the packaging buffer area. Unless they went for the paneling method with a light up/electronics device the panels connect around. If it is a 6'' figure, we can likely assume the box is close to 8+ inches high. Or in that ballpark of a legends style packaging height. Which would make the box close to 3-4 Legends figure boxes in width. All rough estimates. If they went panels method, bottom panel is likely connected already to the electronics device too for easier battery compartment access without having to take the cube apart and have an outside accessible switch to turn it on or off. That seems the most obvious no matter how they constructed it. __________________ Last edited by Snowflakian; 07-02-2018 at 05:21 PM..