[Madame Warlock]

Quote:

Originally Posted by LordMudd

Very nice. How much harder would knee joints be? I always liked the Galoob TNG figures because at least they could sit in chairs on the bridge.


CCC.

quite a bit as it's not possible to do knee joints with just a cross section. again it's more than doable but fiddling around with small parts makes print failure more likely and almost everything i've printed thus far has had some sort of error. this is a mixture of me being new to it and the free to use printer I'm using not being properly configured of course.

That said I remember the DBZ Hybrid figures from a few years back where pretty much nothing but cross sections and managed to be fairly posable, though it was an odd approach.