[Joe Moore]

Quote:

Originally Posted by Kayman26

The darker dome is actually a bit disappointing to me. I think the white translucent one is far more creepy looking. I wonder if a head swap would work?

It will take a bit of work to do that. There are two wires that connect from the head to the back of the figure. You would need to cut those off, and then glue them into place once on the other body.

A better solution might be to head up the head sculpt with a hair dryer around the dome. That may loosen the glue enough to remove them and swap just those. I haven't tried that though, so use extra care and heat incrementally so it doesn't mel the plastic dome.