[Raine24]

Quote:

Originally Posted by firmpulse

EXACTLY! I also use a chainsaw sharpening Dremel bit and carve channels in the top front and bottom front of the ab section to expand the crunch. That bit is about the perfect width. HIGHLY recommend that. Also you can use Acetone to chemically sand any rough areas. Comes out smooth afterwards. I have a few on which the cuts look factory.

Thanks for the tip! Where did you get your Knightfall Bats cape, btw? There are a few figure parts I'll take with me when I'm heading anywhere crafts-y (I'm weird) and one of them is a KF Bat hand so I can look for a fabric match but I've had no luck yet.